Home > Error Code > Triton Atm Error Code 148

Triton Atm Error Code 148

Contents

When this is done, the terminal will operate normally until it is completely out of paper. Clear the error. 2. Replace the dispenser is the error persists. 365 Dispenser BCC error. Clear terminal error code. news

If the error is repeated; proceed to the next paragraph. If the journal prints successfully; verify that all records were audited by performing the Print Journal function again. Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 105 Insufficient notes to learn from There may be an insufficient number of notes in the cassette The most probable cause is either mechanical or electrical failure of the note diverter in the note transport module.

Triton Atm Error Code 148

On 32-bit machines (RL’s, FT’s, RT’s) the electronic journal can store as many as 32,768 records, it is recommended that you do not print the journal. Make sure it is connected to CN1 on the printer control board. Otherwise; replace the dispenser. 2.

If the error clears, put the cash dispenser in service. 5. Verify operation of the power supply. If the error clears, put the cash dispenser in service. 6. Atm Error Codes List If the voltages are correct, and the cables are undamaged and correctly connected, causes of this error may be a defective cable, a defective printer, printer control board or the main

Inspect the card reader assembly. Triton 9100 Error Code 148 Refer to error code 535. 554 Card Reader ñ device reset. If this does not correct the problem, verify that the paper low sensor is correctly attached to the paper bracket and that the cable between the paper low paper feed assembly http://www.accessatm.com/service/atm-error-codes/triton-error-codes/ Remove the cassette and inspect for jammed currency in the width sensor and at the output of the cassette.

Look up the definition on the Hardware Status listing. 4. Triton Error Code 101 Make sure the ribbon cable from the docking station go the card reader is fastened at both ends of the cable and the orientation of the cable is correct. Refer to error code 535. 539 Card Reader ñ Invalid track. Purge the dispenser using the purge command.

Triton 9100 Error Code 148

Follow us on Twitter Tags: ATM Error CodesShare this entryShare on FacebookShare on TwitterShare on Google+Share on PinterestShare on LinkedinShare on TumblrShare on VkShare on RedditShare by Mail http://www.atmdepot.com/wp-content/uploads/2015/09/new-two-color-atm-logo-88px.png 0 0 recommended you read Reset the cash dispenser. Triton Atm Error Code 148 If it works with the door open, remove obstruction causing the diverter to contact the vault door. 4. Triton Error 236 Replenish paper as needed.

If the currency is in “fit” condition and the error persists, consider replacing the cassette or the dispenser. 199 Dispense width errors This status appears when the count at the exit navigate to this website additions deletions revisions none none accession source codes . Don't Worry - I'm here to help you fix it! If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly. 3. Triton Error Code 244

Remove jammed currency. 2. Install the cassette. Verify the blue lever on the left side of the printer in the print position. 3. http://odenews.net/error-code/triton-atm-error-codes.html If error persists; replace the dispenser mechanism. 389 Dispenser offline.

Clear the error. Triton Traverse Error Code 917 Check for and clear any foreign debris the note path. Please try the request again.

Clear the error. 3.

Clear terminal error code. If no jam is located, remove the first note from the cassette. If replacing the modem does not correct the problem; replace the main board. 138 Print failure while printing to the receipt printer. Triton Error Code 616 Pc-Errors.Smartpcfixer.com Error Repair Tool - Free - Recommended PC Error Repair Tool.

Enter the management functions and complete the print journal command. Clear the error and perform a test dispense. Inspect electronic journal to dispenser communication cable for damage. click site If it is necessary to check continuity of the cable assembly, refer to Appendix B for pin out of the cable assembly 5.

Purge the dispenser. Restart the operating system. PURGE the dispensing mechanism. If the error persists; replace the dispensing mechanism. 104 (68h) Unable to clear width sensor.

Clear the error. 2. Install the cassette. If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly 5. Refer to error 500. 506 SPED invalid request.