Home > Error Code > Triton Error Code 244

Triton Error Code 244

Contents

Purge the dispenser with the purge command under diagnostics. Inspect the cassette and feed path for currency that is stuck together or jammed. 2. Replace dispenser if error code persists. 395 Multiple cassette of the same type. Restart the operating system. news

Access ATM Partners, not competitors. If the problem persists; replace the dispenser. 49 (31h) Jam at exit Inspect the feed path for jammed notes. If the error persists, replace the dispensing mechanism. Next try a live dispense (note, you can not fully test this dispenser for this error without doing live dispenses). http://www.atmdepot.com/triton-atm-error-codes/

Triton Error Code 244

Allowable bill sizes are 5, 10, 20, 50, and 100. If no jams are found, remove the note closest the pick rollers in the cassette. 3. Reset the cash dispenser.

If these actions have no effect on dispenser operation, replace the dispenser mechanism. Attempting to operate the cash dispenser without the reject vault will normally cause it to go to an ìOut of Serviceî condition. Test the dispenser by completing several test dispenses. 4. Triton Error Code 151 If these actions have no effect, replace the dispenser. 51 Accountancy error A mechanical failure has occurred.

EOT was received as first character after the first request message was sent. 2. Triton Error Codes Purge the dispenser. If the error persists replace the dispensing mechanism. see this Clear any jammed currency. 2.

This error code may indicate a power loss/firmware restart has occurred at the dispenser controller and no information could be retrieved. Atm Error Codes List If the error persists, replace the card reader 197 Dispenser detect blocked stacker during dispense This error indicates that the bills are not moving the notes through the dispenser fast enough. Restart the cash dispenser. If the error clears, put the cash dispenser in service. 3.

Triton Error Codes

If the cable has good continuity; other possible causes for the error could be the power supply; the Backplane or the CPU Module. 132 Status reports bad double-detect in last dispense http://triton.9600.error.code.134.winwizards.org/ Reset the cash dispenser. Triton Error Code 244 Refer to error code 535. 544 Card Reader ñ Invalid request. Triton Error 236 Test the dispenser by completing several test dispenses.

If the error reoccurs the most likely causes of the problem may be note transport or CMC. 307(37h)[7] Transmission Error. navigate to this website Inspect the cables connected to CN2, CN3, CN4, and CN5. Verify that each cassette is placed in its designated feed channel. Inspect all cables for damage. Triton Error Code 101

Clear all errors and test the dispenser with a live transaction. Replace the dispenser is the error persists. 361 Dispenser sequence error. Refer to error 500. 502 SPED read type error. http://odenews.net/error-code/triton-atm-error-codes.html If error persists, replace the SPED keypad module. 207 SPED not detected This Error/Status Code is valid for units with SPED keypad device installed. 1.

Inspect main board to electronic journal communication cable for damage. Triton Traverse Error Code 917 Doing this will not clear any available memory, and will not aid in clearing Error Code 151.) Below are steps to take to clear Error code 151 on 32-bit machines: 1. Replace the dispensing mechanism. 52 RAM error A mechanical failure has occurred.

Purge the dispenser with the purge command under diagnostics.

Ensure that each cable is securely fastened to its termination point. Verify the error code lights on the dispenser are operating in proper sequence. Verify that all DC voltages applied to the printer control board are correct. Triton Sped Module Refer to the appropriate Service Manual or Quick Reference Guide for instructions. 2.

Clear the error. If no jam is located; remove the first bill from the cassette. This error is not displayed at the Cash Dispenser. click site If these actions have no effect on dispenser operation, print a dispenser status report, scan the click count history, starting at the bottom.

Seat connectors or replace the power supply as needed. 2. Refer to error code 535. 545 Card Reader ñ LRC error. Test the dispensing mechanism by completing several test dispenses. Clear the error.

Telephone hardware problems. (If problem persists call Your Service Provider or Triton Tech Support) 7 BGD_BUSY See Error Codes 3 - 6 10 BGD_LOGON See Error Codes 3 - 6 11 Verify that main board to electronic journal and the electronic journal to dispenser cables securely seated at both ends of the cable. Make sure the connectors are seated securely on the main board and on the electronic journal. 4. Clear terminal error code.

Enter the Management Functions and configure the bill size. 187 Maximum withdrawal not configured Enter the management functions and configure the “multiple amount” parameter. If error persists; replace the dispenser mechanism. 377 Dispenser device error. If the symptoms persist after replacing the Electonic Journal replace the CPU Module. 145 Error in reply from Electronic Journal See the Recommended Actions for Error Code 144 146 No reply belts; gears; cables; or sensors).